Toyota MR2 Community Archive
So you want to install Mk3 seats in your Mk1. It’s really not that hard.
Tools needed:
Torque wrench that can do 27 ft/lbs.
14mm socket/wrench
14mm combination wrench (ratcheting is a definite plus)
Drill (and a metric buttload of crappy bits or 3-4 really good ones)
Safety glasses (of course)
[…]
ere’s a write-up that I’ve been meaning to get to for a while now. Every car has different seat mounting locations. Therefore aftermarket seat manufacturers must sell brackets specific to the car. Sometimes this...
After getting tired of looking at the old dull headliner and dirty sunvisors for the past 10 years, I decided to try out the Vinyl & Fabric paint/dye. You can purchase this at your...
Okay, so this seems to come up every now and then, usually people wanting to know if they can fit an Altezza engine into their MR2. A few people have fitted FWD engines in...
Engine: There are too many to count as toyota used them in alot of vehicles 3VZ-FE toysrme? 4VZ-FE JDM? 5VZ-FE Found in 1995.5-2004 Tacomas, 96-02 4runner, 95 T100(Rumor has it this was a Disti...
Well… This seems to come up every now and then. People complaining that the beams engine is too rare/expensive. So here’s my guide, on how to go about getting a 200+hp 3SGE, for the...
What to do with that rusting heat shield? As good a sports car as Toyota made the Roadster it is by and large an accepted fact the build quality could and should have been...
Removing the old vents First of all you need to remove the actual plastic vent from your car. It is held in place by three clips along the front edge and two protruding clips/lips,...
When my lovely new Roadster arrived, it had no stereo fitted. After a bit of investigation I have found out that the stereo unit is a “Point of Entry” part. i.e. All Roadsters are...
This can be easily seen by looking at the soft-top when it is folded down fully or by looking in the hood lining when the hood is partially down (See pictures below.) You will...
