How to: Change Transmission Fluid in a MR2 Spyder
Changing the transmission fluid on an MR2 (MK3) is quite easy and should take 30 minutes to one hour. Required Tools 12mm socket (speedo cable hole). 24mm socket (15/16 inch) (this is a big...
Author: Midship Runabout
How To: Fix Throttle Cable
Well I had a fraying throttle cable that was getting hung up at times when backing off the throttle… After further inspection I noticed that the throttle cable was fraying and was getting caught up not letting the cable slide smoothly to close the throttle plate. Well after a call to “SATAN” I was quoted around 80 bux for about 1.5feet of throttle cable. A bit much if you ask me, and im sure I could do this for cheaper.
MarkIII Inlet Pipe
Ladies and Gents, Having just test fitted one of the new batch prior to packing and shipping, I figured you might benefit from some instructions. This latest version is slightly different from the last...
Kirk’s Urethane Motor Mounts
In reality this is not difficult, other than undoing bolts, and doing them back up again. The problem with undoing is rust, wear and stiffness, the problem with installing is getting everything back into...
How To: Install TRD Spoiler
This is a fairly easy fitting. You have to make sure your measurements are right, and that you have confidence to drill into your engine lid. This type of spoiler was originally available in...
How To: Change The Clutch Line
Changing The Clutch Line
Tools:
10mm Line Wrench
12mm Line Wrench
Regular Pliers
Lift or Jack/Jack Stands
How To: Replace Euro Side Repeater
A small mod it may be, but side repeater replacement (for pre-facelift cars) is one of the most effective, and thus popular. I have just done mine, so decided to take a few pictures...
How To: Remove the ECU Fuse and Negative Battery Terminal Camp
When I tried to add these pics to the n00b’s guide on MAF cleaning, it said there were too many pics. So, it gets a thread all by itself. When you clean the MAF,...
DIY: Changing Door Inserts
After recently changing my seats the red door cards became a little out of place so as usual i thought it would be worth trying to change them myself I went along to one...
How To: Replace Radiator Fan
First off I’ll talk a little about how I “determined” my motor was bad. I was poking around in the frunk when the fans came on and I looked down to see that only...