- 10mm Line Wrench
12mm Line Wrench
Lift or Jack/Jack Stands
I used regular wrenches but it’s not advised.
1. Completely loosen fittings on both sides of the clutch line.
2. Remove both retainers.
3. Remove old line.
4. Install new line in its place making sure to align the fittings correctly.
5. Reinsert both retainers.
6. Tighten down both fittings.
Now you will need to refer to my How To: Bleed The Clutch.
This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website. Article and photo submissions are property of the contributing author.