Tagged: Spyderchat

How To: Remove Transmission

This is a “how to” with some pictures that may assist in taking out our manual tranmissions. If your doing the removal yourself like I did you should alot 4 plus hours for your...

How To: Replace Shift Cable

Step one. You should have everything apart and the key focus is the hard part which is passing the cable though. Step Two You need to cut the cable here. The cable will now...

5

How to: Change Air Filter

Okay here’s a write up for an air filter change. Some things may vary since I have no heat shields but this should get you through it for the most part.

Tool needed-

Phillips screwdriver

Parts needed-

New airfilter

Begin.

0

OBD Codes – the complete list

P0100 Mass or Volume Air flow Circuit Malfunction P0101 Mass or Volume Air flow Circuit Range/Performance Problem P0102 Mass or Volume Air Flow Circuit low Input P0103 Mass or Volume Air flow Circuit High...

0

How to: Adjusting the Clutch Pedal

Adjusting The Clutch Pedal Ok I’ve read “Path To Shifting Nirvana” And it wasn’t quite clear to me on how to actually adjust the pedal. So I took some a picture and figured I...

0

How To: Bleed The Clutch

Bleeding The Clutch Tools: 8mm Wrench Air Compressor Power Bleeder Fluid Supply Bottle Lift or Jack/Jack Stands 1. Jack up car and set on jack stands. (Or use your lift) 2. Use the power...

0

How To: Change Brake Fluid

Something I have been putting off for years (literally) because I didn’t want to deal with the hassle is flushing out my brake fluid. Finally I found the griots garage one man brake bleeder which sounds...

How To: Replace Radiator Fan

First off I’ll talk a little about how I “determined” my motor was bad. I was poking around in the frunk when the fans came on and I looked down to see that only...

0

Winter Tire Information

Ok I promised myself I would do this a long time ago but never got around to it. I finally opened word tonight and got started thinking I would continue to write this over...

How To: Replace Air Inlet Elbow

Well after seeing Markiii elbow inlet on mr2roc and ChrisGB’s elbow tubing replacement, I though I should try it out since everyone likes better airflow and I had been thinking about getting a CAI...