Sunroof Rattle
After living with the sunroof rattle ever since I got the car, decided to fix it today. It’s so easy, don’t know why I waited this long. 1) Remove the sunroof. Now you need...
Toyota MR2 Community Archive
After living with the sunroof rattle ever since I got the car, decided to fix it today. It’s so easy, don’t know why I waited this long. 1) Remove the sunroof. Now you need...
The pics below are during my full suspension/brake system rebuild. So they will be a little different than yours since I was removing everything. *Procedure of pressing the bushings out with just 2/3 jaw...
Removal 1) Raise and support the rear of the car on jack stands. 2) Disconnect the negative cable from the battery. 3) Remove the under-carriage cover (bunch of 10mm bolts). You should then have...
Since I had the transmission out of the car to do the 20V engine swap, I decided to rebuild the clutch slave & master cylinder. It’s a good idea to rebuild/replace both at the...
Replaced my brake lines with stainless steel braided lines during my suspension project. Ordered them from Nopi. 1) Bleed out as much brake fluid from the system as you can. 2) Remove...
Some say rebuilding the clutch master cylinder is not worthwhile, that a rebuilt unit will still leak. However, I believe these problems ocurred because the actual cylinder wall was pitted and in bad shape...
Changing out the Oxygen Sensor is very simple repair. If your Check Engine Light illuminates intermittently while driving on the freeway, most likely it’s an O2 sensor problem. Poor gas mileage could also mean...
I’ll try to go about explaining the caliper rebuilds. However, this was during my suspension rebuild, so some of the pics may look weird… Tools needed: Various sockets and wrenches Screwdriver Rebuild kit ~$20(Toyota...
If you ever happen to work on the coolant system, and have yet to do this, remove the radiator and have it flushed/cleaned out. After 15 years of use, the rad can get quite...
Over time it is almost gauranteed that at least one of your parking brake cables will freeze up & need replaced. The cables run about $50 each at the dealer and that’s the only...