2) Remove the clip and bleeder tube with the bleeder plug from the bracket.
3) Remove the 2 bolts holding the slave cylinder to the transmission and remove the cylinder.
Installation of the Rebuild Kit
1) Here’s the slave out of the vehicle.
2) Remove the boot from the cylinder. You may have some brake fluid leak come out when you remove the boot, if the piston seals have been worn. Also remove the pin from the boot, as you will be reusing the pin.
3) Now you will see the piston inside the cylinder. If your seals are as worn as mine were, you can be able to remove the piston from the cylinder with your finger. If you can’t do this, then you will need compressed air to ‘pop’ the piston out of the cylinder.
Piston and spring out of the cylinder:
The old and new parts beside each other. Notice the o-ring seals on the 2 pistons. The old ones are flat, whereas the new ones have distinct ridges.
4) Clean up the inside of the cylinder with denatured alcohol or clean brake fluid. Also clean up the old pin, use very fine sandpaper if necessary.
5) Attach the new spring to the new piston. Lube up the seals with grease (use the same type of grease found in the caliper rebuild kits).
6) Push the spring/piston into the cylinder, spring first of course.
7) Slide the pin into the boot. This takes quite a bit of force, as the fit is real tight.
8) Pack grease on the face of the piston, wehre the pin will sit.
9) Place the pin onto the piston and slide the boot over the lip of the cylinder.
10) Reinstall the slave cylinder onto the transmission opposite of how you removed it. This will be a little tough lining up if your transmission is still in the car. A ton easier with the tranny out of the car of course.
11) Thoroughly bleed the clutch.
This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website. Article and photo submissions are property of the contributing author.
