How to: Adjusting the Clutch Pedal
Adjusting The Clutch Pedal Ok I’ve read “Path To Shifting Nirvana” And it wasn’t quite clear to me on how to actually adjust the pedal. So I took some a picture and figured I...
Tagged: adjust
How To: Bleed The Clutch
Bleeding The Clutch Tools: 8mm Wrench Air Compressor Power Bleeder Fluid Supply Bottle Lift or Jack/Jack Stands 1. Jack up car and set on jack stands. (Or use your lift) 2. Use the power...
Aftermarket Seats
ere’s a write-up that I’ve been meaning to get to for a while now. Every car has different seat mounting locations. Therefore aftermarket seat manufacturers must sell brackets specific to the car. Sometimes this...
How To: V6 Swap Primer
Engines: Compatiblity / Grocery List
1997+: 1MZ-FE
Best choice for swap.
1992-1996: 1MZ-FE
Compatible, but not recommended.
Early 90’s 3vz is proven to work also*
[…]
3SGTE Engine Removal / Build-up Pictures
I followed the service manual as well as the excellent write up on this site: http://www.mrtwo.net/mr2modproject/mr2modproject.htm to remove the engine out of the bottom of the MR2. The reason for removing the engine was...
How To: Replace the Struts
Here I am replacing a very used set of Tokico Illuminas with KYB AGX struts. The old struts were shot due to a poor choice of boots. These are just notes and pictures and...
How To: Adjust MR2 Valve Clearance
Here are some notes pertaining to adjusting the valve clearance on a 1991 Toyota MR2 Turbo. Start off by removing the basics – the strut tower brace, and air tubes leading to the throttle...
Cam Degreeing
Here are some tips and info on how to degree cams for the 3SGTE. This article does not cover cam install, just the degreeing process for aftermarket cams. If you do not degree your...
Distributorless Ignition For The MR2
RX-7 twin tower ignition coils installed in MR2 Turbo. The goal of the project was to design and build an affordable ignition upgrade for the MR2 Turbo (3S-GTE). The original plan was to build...
Do it yourself Water Injection
Here are some images of the mcmaster car nozzles mounted inside the throttle body. An overview video of the water injection setup is here (WMV format 8MB) – it’s a little nerdy – but...