Toyota MR2 Community Archive
Invincashield is a product made by 3M. This product goes by other names, and/or is made by other brands (ie Stongard). You can find some info on a MR2 Spyder specific installation here http://www.smiley.net/spyder/invinca.htm...
Figured this was an easy enough task, and again, like many of my repairs on this site, I’ve had never changed this out since I’d owned the car at the time. Plus it was...
1) Norm: To start with, turn the engine to top dead center (always do this to pull the distributor). You do that by making sure the “0” timing mark on the pulley lines up...
I just installed the TRD member braces on my car, and have a few bits to add to Whelps “how-to” on Spydermagazine.com First of all the front brace: Its a doddle, if you can...
Here is a brief document describing how to remove (or rather how I remove) the turbocharger from the MKII MR2. The reason for removing the turbo here is because a couple of the exhaust...
For those of you that dont know, when designing the MR2 Toyota went down the path of making it a Ultra Low Emissions Vehicle (ULEV). Doing this meant adding a whole load of extra...
RX-7 twin tower ignition coils installed in MR2 Turbo. The goal of the project was to design and build an affordable ignition upgrade for the MR2 Turbo (3S-GTE). The original plan was to build...
Since I plan to run some quicker times this year, I thought it would be a good idea to pick up a set of Axle upgrade parts from ATS Racing. Axle breaks are common...
reddy 720cc top feed injector. Part# 1350072 On the right are the fittings that come with the HKS Fuel Rail. Insulator, bung/adapter, o-ring. NOTE: The picture also shows an o-ring and insulator on the...
Here’s some info on how to swap out the fuel pump in a MKII MR2. This took me at least 8 hours of actual work. I broke it up over a period of about...
