Author: Midship Runabout

0

3SGTE Engine Removal / Build-up Pictures

I followed the service manual as well as the excellent write up on this site: http://www.mrtwo.net/mr2modproject/mr2modproject.htm to remove the engine out of the bottom of the MR2.  The reason for removing the engine was...

0

20V Blacktop Dyno Results

Here are the results: 137whp & 111wft-lbs. This is with 103 octane unleaded gas. I don’t really trust the A/F ratio measurements. The tool they use for that is a little suspect, since it...

4AGE Cooling System 101 0

4AGE Cooling System 101

The water pump pumps water into the block, it circulates into the head and comes out of the head on the passenger side above the water pump. The water travels passed the cap and...

How To: Bleed MR2 Cooling System

Draining: Complete service manual instructions can be found here.  The MR2 has four drain plugs, one in the radiator, two in the piping underneath the car, and one in the engine block.  When I...

How To: Replace the Starter

How To: Replace the Starter

To replace the starter on a mk1: 1.  Disconnect the ground cable from the battery. 2.  Jack the car and use stands. 3.  Under the car use a 14mm socket a short extension and...

How To: Install AutoLab Level 2 Turbo Kit

This page contains notes and pictures for the installation of the Autolab Level 2 turbo kit. This kit contains the following components:

T3/T4 50trim water cooled Garrett turbocharger

Tial wastegate

Necessary fittings/gaskets for wastegate

Manifold

How To: Change Transaxle Fluid

Changing the transaxle (transmission) fluid on an MR2 turbo is actually very simple.  The only difficult part is removing the drain and fill plugs which can be somewhat stubborn, particularly if they have never...

0

Exterior Detailing 101

This is going to be a three part series into exterior detailing. Our test subject is my sisters Black 2000 Toyota Camry with many paint imperfections and blemishes. After the detail is complete I...

How To: Port the Exhaust Manifold

While having the exhaust manifold, and turbocharger off, I decided to attempt to port match the exhaust manifold to the head ports, and the exhaust manifold to turbocharger ports.  I decided that attempting to...