How To: V6 Swap Primer
Engines: Compatiblity / Grocery List
1997+: 1MZ-FE
Best choice for swap.
1992-1996: 1MZ-FE
Compatible, but not recommended.
Early 90’s 3vz is proven to work also*
[…]
Tagged: remove
How To: Install Kirk’s Motor Mounts
I knew that there would be an initial period of vibration post-install, but that it would calm down eventually. The only thing I was missing was an illustration of what, exactly, one is supposed...
3SGTE Engine Removal / Build-up Pictures
I followed the service manual as well as the excellent write up on this site: http://www.mrtwo.net/mr2modproject/mr2modproject.htm to remove the engine out of the bottom of the MR2. The reason for removing the engine was...
How To: Bleed MR2 Cooling System
Draining: Complete service manual instructions can be found here. The MR2 has four drain plugs, one in the radiator, two in the piping underneath the car, and one in the engine block. When I...
How To: Replace the Starter
To replace the starter on a mk1: 1. Disconnect the ground cable from the battery. 2. Jack the car and use stands. 3. Under the car use a 14mm socket a short extension and...
How To: Install AutoLab Level 2 Turbo Kit
This page contains notes and pictures for the installation of the Autolab Level 2 turbo kit. This kit contains the following components:
T3/T4 50trim water cooled Garrett turbocharger
Tial wastegate
Necessary fittings/gaskets for wastegate
Manifold
How To: Remove Ball Joint
I thought I would share my experience with removing my front ball joints on my ’93 T. I have never done this before on any car so it was all new to me. I...
How To: Replace the Struts
Here I am replacing a very used set of Tokico Illuminas with KYB AGX struts. The old struts were shot due to a poor choice of boots. These are just notes and pictures and...
The only good precat…is a dead one!
Disclaimer: Altering or removing any part of a manufacturer’s installed emissions system is against Federal Emissions Laws in the United States. Those members who choose to do this agree they are doing it of...
How To: Adjust MR2 Valve Clearance
Here are some notes pertaining to adjusting the valve clearance on a 1991 Toyota MR2 Turbo. Start off by removing the basics – the strut tower brace, and air tubes leading to the throttle...