Engine Vents

Here’s some pictures of engine vents Pat decided he needed after he saw similar vents selling unpainted on Erebuni’s website fo $75 US a side. 🙂 To make these, he just traced an outline on the bottom of the engine covers with a marker and a washer. Next, he dremeled the line wasting many a cut off wheel. To finish off, some rubber flexible molding from a window shop was used as trim. The mesh was attatched with black silicone on the underside. Cheap and easy, and should allow heat to dissapate from the engine faster, dropping temps a little bit.  







This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website. Article and photo submissions are property of the contributing author.

You may also like...

Leave a Reply