D: Disconnect balljoint from lower suspension arm. 2 17mm bolts.
E: Disconnect adjustment arm from brake assembly.
Pop axles through the brake assembly. Before you do this you will have to undo the two strut bolts that connect the strut to the axle carrier (19mm). Use a piece of wood and hammer to hit the axles straight towards the engine. This may take a lot of hits, keep at it, it will free up, and pop through.
They should come out of the carriers and look like this
Remove right hand (passenger) axle only. There are a few ways to do this, the one I used was to remove the axle carrier and just pull the axle out. This first pic is looking through the crossmember at the back of the engine. From below, remove the following
This documentation in no way replaces the Toyota MR2 Repair Manuals. The purpose of this content is only to provide supplementary information to fellow MR2 enthusiasts. Midship Runabout and its contributing authors will not be held responsible for any injury or damages that may occur as the result of practicing any of the methods or procedures described within this website. Article and photo submissions are property of the contributing author.
