Midship Runabout

0

20V Blacktop Swap Exhaust

For the exhaust, you need to decide if you want to use the 16V manifold or the 20V. The 20V manifold is a much more efficient design, however involves more customization that the 16V....

0

20V Blacktop Dyno Results

Here are the results: 137whp & 111wft-lbs. This is with 103 octane unleaded gas. I don’t really trust the A/F ratio measurements. The tool they use for that is a little suspect, since it...

Supra Fuel Pump Power Mod

This mod is intended to supply the maximum amount of voltage available to the fuel pump, and upgrade the wires when using a Supra pump which usually pulls right around 20 amps, by getting...

0

Oilpan Airflow Mod

The purpose of this mod is to allow the underbody airflow to hit the front of the oilpan, and carry away some of the heat in the oil. The mod was found on a...

0

TVIS Disconnect

TVIS Disconnect = MID RANGE GRUNT There are really only a few free mods, add this one. Give it a shot, if you don’t like it, switch it back! On hearsay, we disconnected our...

4 EGT to 1 Switched Gauge Install

Forward: We do NOT reccommend drilling into your ex. manifold with it on your car. Shane and Pat pulled the motor shortly after, and when Shane pulled the head, he found evidence that this...

0

PVC pipe K&N Breather Install

Just a few pics to show the part # and where the breather goes. Also highlighted the plug you need to use. You can buy the Breathers at most Auto Parts Stores that carry...

0

Invincashield Install

Invincashield is a product made by 3M. This product goes by other names, and/or is made by other brands (ie Stongard). You can find some info on a MR2 Spyder specific installation here http://www.smiley.net/spyder/invinca.htm...